BoardCanvas
Sign In
Guides & comparisons

Design a Custom Wide Carving Snowboard

Direct Answer

Wide carving boards exist so bigger boots can tilt the board to extreme edge angles without toe or heel drag: typical wide waists are 26 cm, Prior's MFR 168 extra-wide runs a 27 cm waist for US 12–14 boots, and custom shapes go to 28.5 cm. Design the graphic for that wider canvas free in BoardCanvas — the extra-wide Donek Knapton Twin is a built-in model.

By Ray · BoardCanvas · Model specs checked against the official maker pages, November 2026

Key facts

Standard wide waistAbout 26 cm (Prior wide models)
Extra-wide27 cm waist suits US 12–14 boots (Prior MFR 168 XW)
Maximum customWaist up to 28.5 cm, tip/tail up to 34 cm (Prior custom shapes)
Drag thresholdConsider wide from boot size US 10.5+
Example model in the editorDonek Knapton Twin (extra-wide true twin)

Use the extra canvas

  • A 26–30 cm waist shows roughly 15–20% more artwork than a standard board — wide-format art and bigger type finally fit.
  • Carving photos are shot from the side at full tilt: the base graphic is unusually visible, so design the base too, not just the topsheet.
  • Symmetrical art suits carving twins like the Knapton Twin, which are ridden switch between carve sets.

Design these boards in this style

Real models in this category with exact templates in the editor:

Frequently asked questions

What waist width do I need for US 13 boots?

Around 27 cm. Prior's MFR 168 extra-wide (27 cm waist) is made for US 12–14 feet; larger feet can go custom up to a 28.5 cm waist.

Which wide carving board can I design online?

The Donek Knapton Twin is a built-in BoardCanvas model — an extra-wide true twin made for deep carving. Design and preview it in 3D for free.

Design it now — free

Browser editor, interactive 3D preview and PNG export are free. No account needed.

Design a wide carving board