Keep Artwork Clear of Binding Inserts: Placement Guide
By Ray · BoardCanvas · Specs checked against the makers' official pages
Keep faces, text, logos and any detail you care about out of the binding insert zone: the 4x4 insert pack occupies the centre of the board where your bindings mount, and boots cover most of the middle anyway. Put hero art on the nose third and tail third, run patterns (not subjects) through the middle, and remember makers' placement tolerances — Donek quotes about ±1/4 inch side-to-side and ±1/2 inch tip-to-tail.
1. Where the dead zone is
Standard boards use a 4x4 insert pattern (some use Channel systems). The two insert packs sit under your front and back bindings. Anything printed there is hidden by the binding and boot — or worse, half-hidden, with a disc cutting through a face.
2. The placement checklist
- Hero subject: nose third or tail third, never centred between the feet.
- Text and names: near the tail, below the rear inserts, sized for the maker's ± tolerances.
- Patterns, gradients and textures: free to run through the middle — they are insert-proof.
- Symmetrical boards: check the design in both orientations before exporting.
3. Check it the way the rider sees it
BoardCanvas's editor shows insert and safety zones on the canvas and the 3D preview shows the board with proportions as ridden. If it reads well there, it will read well on snow.
Know which insert system your board uses
The keep-clear zone depends on the mounting system. The classic 4×4 pattern (and its denser 2×4 variant) puts two rows of inserts along each stance position — this is the pattern BoardCanvas templates draw, and the one Donek and Prior boards use. Burton's Channel replaces the rows with a continuous slot, so the keep-clear area becomes a full-length band down the middle of the board rather than two clusters. A few older boards use Burton's 3D pattern, a triangle of holes per foot. If your design has a face or a line of text, the Channel is the most demanding of the three: anything centred is under a binding or a disc somewhere along its length.
A pre-export check that takes two minutes
- Measure your stance width and angles on your current board and recreate them mentally on the template: the discs cover roughly a 10 cm circle at each foot.
- List the three elements you would be sad to lose — a face, a logo, a signature — and confirm none of them sits inside either disc circle or, on Channel boards, inside the centre band.
- Rotate the board in the 3D preview with bindings imagined at your real stance: check the graphic at riding distance (2–3 metres), not at zoom. Small text near inserts is the first casualty.
- If an element must live between the feet, raise its contrast and scale it up: half of it will be under a boot, so design it to read in two halves.
Sources
Create Your Custom Snowboard Deck
Apply these specs and design your unique AI graphics in 3D now.